A penetrating oil base semi-transparent stain for new and previously stained exterior wood surfaces.
This product is formulated for use on siding, decks, fences and outdoor wooden structures.
|
|
|
| Color: |
Clear |
|
| Finish: |
Flat |
|
| Density: |
7.70# per gallon |
|
| Clean-Up: |
Mineral Spirits |
|
| VOC: |
540 gm/liter |
|
| Solids: |
Weight
Volume |
41.6%
31.3%
|
|
| Flash Point: |
105ºF |
|
| Coverage: |
265-525 sq. ft. per gallon
Depends on porosity. |
|
Theoretical
Coverage: |
525 sq. ft. @ 1.0 dry mil |
|
| Dry Time: |
Four hours to touch @ 70°F and 50% relative humidity. Overnight to recoat @ 70°F and 50%
relative humidity. |
|
| Application: |
Brush, roll or spray. Do not apply when surface or air temperatures are below 45°F or
when temperatures are expected to drop below 45°F within 24 hours. |
|
5800 & 5802 NW Weathergard colors and protects wood while allowing the natural texture and grain to
show. Semi-Transparent Oil Stain reduces moisture penetration, wood checking and mildew growth.
Note: Maintain a wet edge and brush in the direction of the wood grain. Do not allow excess to dry on the
surface. For best results, apply to bare wood surfaces according to directions on label.
|
Alkyd
Titanium dioxide & extender pigments
Contains no lead or mercury
|
Surfaces must be sound, dry and clean. Remove previous coatings that have poor adhesion.
Wash areas where mold and mildew are present. Remove all dirt, oil, grease, wax and/or other contaminant. Repair
cracks and fill voids. De-gloss shiny surfaces by lightly sanding. Clean and prime all bare metal surfaces with an
appropriate primer. Prime areas as needed. Test for adhesion and compatibility with existing finishes.
|
Never pour leftover coating down any sink or drain—use up material on the job or seal can and
store safely for future use. Do not incinerate closed containers. For specific disposal or recycle guidelines, contact
your local waste management agency or district. Always attempt to recycle whenever possible.
|
Limited Warranty: Miller Paint Company, Inc. warrants to the purchaser that this product
will provide satisfactory performance when applied according to label directions. If this product does not perform
to specifications, return unused portion along with sales receipt to place of purchase. As the sole remedy to purchaser,
dealer will, at its option: provide additional product to correct affected areas, replace with product of equal value or
refund the purchase price paid for this paint product. Failures caused by poor surface preparation, improper application
or a breakdown of the underlying surface or previous paint film are not covered by this warranty. THIS WARRANTY
SPECIFICALLY EXCLUDES LABOR OR COST OF LABOR OR INCIDENTAL OR CONSEQUENTIAL DAMAGES ASSOCIATED WITH THE USE OF THIS PRODUCT.
|
WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD
ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum
and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
|
